November 13, 2026

Some vibration during the spin cycle is normal, but a washer that bangs, shakes hard or “walks” across the floor is a problem. Heavy shaking can damage the washer, the floor and nearby walls or cabinets. The good news is that many causes are easy to check.

Common Causes You Can Fix

Unbalanced load

The most common cause is a load that bunches up on one side of the drum. Single heavy items such as a bath mat, a comforter or a pair of jeans are typical culprits. Stop the cycle, spread the laundry evenly, and add a few similar items to balance a single bulky piece.

Washer is not level

If the washer rocks when you push on opposite corners, it is not level. Adjust the leveling feet until all four touch the floor firmly, check with a level on top of the washer, and tighten the lock nuts on the feet so they do not loosen again. Some models have self-adjusting rear legs that may need to be reset by tilting the washer forward and setting it back down.

Weak or uneven floor

Washers on wooden floors, especially in older rowhomes and upper-floor laundry areas, can transfer more vibration. A floor that flexes makes the washer bounce. An anti-vibration pad can help, but a floor that visibly moves may need attention from a contractor.

Shipping bolts left in a new washer

New front-load washers are shipped with bolts that lock the drum in place. If they are not removed during installation, the washer shakes violently on the first spin. Check the back panel for these bolts and remove them as the installation manual describes.

Worn Parts That Cause Shaking

If the load is balanced and the washer is level but it still shakes, a part that controls drum movement may be worn:

  • Shock absorbers or dampers on front-load washers absorb the motion of the drum. When they wear out, the drum moves more and hits the cabinet.
  • Suspension rods or springs on many top-load washers hold the tub in place. A broken or stretched rod lets the tub swing.
  • Drum bearings wear over time and often cause a loud rumbling or grinding noise along with shaking.
  • Drum support (spider arm) on front-loaders can crack or corrode, which lets the drum wobble.

Why You Should Not Ignore It

Running a washer that shakes violently puts stress on the motor, the bearings and the cabinet. It can also loosen water hoses and cause leaks. Many washers detect an unbalanced drum and stop spinning or extend the cycle, which can leave clothes soaking wet.

When to Call a Technician

Call for service if shaking happens with small, balanced loads, if you hear grinding or banging from the drum, or if the drum feels loose or wobbles when you move it by hand with the washer off. A technician can check the suspension, shocks and bearings and replace the worn parts.

Need Help in Philadelphia?

If your washer still shakes after leveling and balancing the load, Appliance Repair Brothers provides same or next day on-site washing machine repair in Philadelphia and nearby areas. We give a 90 day warranty on all repairs and manufacturer parts. Call 1.267.690.8148, Monday to Friday 8am to 6pm, to book a visit.